DU9900Z DLP Projector - User Manual
35
UM99000721EN00
Connecting to a Control Equipment
The projector has the following control port for connecting to the control equipment:
HDBaseT/LAN (Network control):
The projector supports network control. LAN and HDBaseT share the same port. If
only network control is used, you can connect the LAN on the projector to PC or through the local network. Refer to the
Remote Communication Manual for detailed information.
RS-232 (RS-232 control):
The projector can be remote-controlled by connecting the projector to a PC or control system
through the standard 9-pin serial cable (Straight Through Serial Cable). Refer to the Remote Communication Manual for
detailed information.
Wired remote control:
If the projector cannot receive the IR signal from the remote control due to the overly long
distance or obstacles, you can connect the cable to the IR remote control or the external IR transmitter (optional) via the
WIRE input port to expand the working range of the remote control.
3D Sync Out/In:
Connect to 3D IR sync signal transmitter or device.
Note:
When the terminal of the remote control cable is inserted to the wired control terminal of the projector, the
projector will automatically switch to the wired control mode and cannot be controlled through the IR signal
of the remote control. Disconnect the wired control terminal on the projector if you want to control through
the IR signal of the remote control.
If the wired remote control cable or the external IR transmitter is inserted to the incorrect port such as
Trigger, the remote control or the IR transmitter may be damaged. Make sure whether the port is correct.
