Page | 16
4.
Push the feed card down in between the bottom laminating roller and grey support plate (4.2 & 4.3). Ensure the Matrix
Duplex writing is facing the feed table (see below 5.1 & 5.2).
5.
Push the feed sheet down until it reaches the bottom foam idle bar and thread
around the back (5.3). Pull towards the front of the system and load bottom roll
of film. Ensure this is centralized and matches the top roll of film. The bottom
film is a mirror image of the top. The adhesive should always face you
when pulling of the roll (5.4).
6.
Fold the film over on itself and secure it to the feed sheet (6.1).This needs to be
as flat as possible (6.2). Slacken the film to the floor to allowing enough to pull
the feed sheet out of the system (6.3).
4.1
4.2
4.3
5.1
5.2
5.3
5.4
6.1
6.2
6.3
