Page | 11
8.
Drape the film over the chrome roller and feed table (8.1). Push a plain thick card in-between the chrome roller and feed roller
(8.2), while pushing the card through turn the film clockwise to release the tension (8.3). Push the card until the back edge is
inline with the feed gate (See below figure 9.1).
9.
Put the safety guard back on ensure the latch is pushed in (9.2), otherwise the eye on the display will flash and the machine will
not run. Lower both pneumatic laminating roller and pull roller (the LED’s will illuminate blue when the roller is in the down
position - figure 9.3).
Paper sensor signal for no paper
10.
Put a piece of plain card up to the feed gate. Press forward run and select your desired speed (10.1). Let the machine paper
sensor fail (10.2). Set your temperature to match the speed you have selected (i.e. 105
o
C 2.5mpm [mechanical meters per
minute] for Pneumatic/Duplex models and 120
o
C 2mpm for Metallic models).
8.1
8.2
8.3
9.1
9.2
9.3
10.1
10.2
