Vivax TV-55UHD122T2S2SM, Instruction Manual

Page: 267 / 284

VIVAX
ENG
48
I have connected an external
source to my TV and I get no
picture and/or sound.
• Check for the correct output connection on the
external source and for the correct input connection
on the TV.
• Make sure you have made the correct selection for
the input mode for the incoming signal.
When I turn On my
television, there is a few
second delay before the
picture appears. Is this
normal?
• Yes, this is normal. That is the TV searching for
previous setting information and initializing the TV.
Picture is normal, but no
sound.
• Check the volume settings.
• Check if Mute mode is set "on".
Sound but no picture or
black and white picture.
• If black and white picture first unplug TV from AC
outlet and re-plug after 60 seconds.
• Check that the Colour is set to 50 or higher.
• Try different TV channels.
Sound and picture distorted
or appear wavy.
• An electrical appliance may be affecting TV set.
Turn off any appliances, if interference goes away,
move appliance farther away from TV.
• Insert the power plug of the TV set into another
power outlet.
Sound and picture is blurry
or cuts out momentarily.
• If using an external antenna, check the direction,
position and connection of the antenna.
• Adjust the direction of your antenna or reset or fine
tune the channel.
Horizontal/vertical stripe on
picture or picture is shaking.
• Check if there is interfering source nearby, such as
appliance or electric tool.
The plastic cabinet makes a
"clicking" type of sound.
• "Click" sound can be caused when the temperature
of the television changes. This change causes the
television cabinet to expand or contract, which
makes the sound. This is normal and the TV is OK..
Remote control does not
work.
• Confirm that TV still has power and is operational.
• Change the batteries in the remote control.
• Check if the batteries are correctly installed.