Vivax TV-55UHD122T2S2SM, Instruction Manual

Page: 244 / 284

ENG
VIVAX
25
• Connecting a Computer
Connect the D-Sub cable to "VGA" on the rear of your set and the other end
to the Video Card of your computer.
Connect the stereo audio cable to "AUDIO" on the rear of your set and the
other end to "Audio Out" of the sound card on your computer. Primarily this
unit is intended for use as an LCD TV. If using as a monitor, and compatibility
is a problem; please contact the manufacturer of the PC Video/Graphic's card
for further support. Perfect compatibility is not warranted.
Connecting USB data Devices
Connect a USB device for browsing photos, listening music, watching movies.
This USB port also can be used for servicing and updating software on your
TV.
• Connecting Digital Audio
Connect an Coax RCA audio device to this jack.
• Connecting Headphones
Headphones can be connected to the headphone output on the side of your
set.
USING THE REMOTE CONTROL
• Turning your TV on and off
Turning off to standby mode: Press [ ( | ) Power Standby] on the back RHS
panel or on the remote control to switch to standby mode. You can activate
the unit again by pressing [ ( I ) Power Standby].
Power indicator: Light indicates standby mode. There will be no light when
the power switch is in the off position.
► NOTE
Remove the connection from the wall power outlet if you do not intend to use the unit for
long periods, for example if you plan to be away a few days. Wait at least 5 seconds after
turning off if you want to re-start the TV.
• Selecting the Input Source
Select the Input Source depending on the video device you have connected
to your TV.
To select the Input Source: Press [Source] button. When the list of Input
Source appears, press [▲/▼] to select the source, then Press [
OK
] to
connect.
• Adjusting the volume
Press [
VOL▲/VOL▼
] to increase or decrease the volume.
Press [
MUTE
] to turn the sound off. Press [
MUTE
] again to turn the sound
back on.
• Changing channels
Press the [
CH ▲/CH
▼] buttons to go to the next higher or lower channel. Or,
Press the number buttons to select a channel. For example, to select channel
12, press [1], then press [2].