4 Check Out Procedure
2. Turn the transmitter on and set to low output power.
3. Place the receiver tip directly on one of the conductive wires.
4.
The signal strength reading should be above 800 constant and not fluctuate.
5. While watching the signal strength readout, wiggle each connection point on the
conductive attachment at the direct connection socket and at the clamp end of
each of the conductive attachment wires (red and black). The signal strength
should not change. Any fluctuation in the reading indicates a loose or broken wire
within the conductive attachment.
6. Repeat step 6 on the other conductive wire.
7. Turn the transmitter OFF.
Page 14 of 35
™
