Vity VIMATY 70EIB, User Manual

Page: 15 / 33

VIMATY 70
5.2.1 - IR learning with the integrated infra-red receiver.
Vimaty can directly learn the infra-red codes from your remote controls. Use preferably the
mode of "Normal" learning which is a mode which controls the measurements taken before
validating them. This mode is thus more protected than the "Forced" mode that accepts all taken
measurements.
•
Check the absence of parasitic infra-red sources (fluorescent lights, television, LCD screen)
•
Pass in learning mode by using the setup mode. The following screen appears :
•
Choose the learning mode with the button "Learn"
•
Choose the type of learning with the button "Normal".
•
Choose the infra-red code to learn by pressing the button on the touch screen.
•
The message "IR learning in progress" appears at the bottom of the screen. The touch screen
is not read any more and if you want to leave the learning mode, press one pushbuttons of
Vimaty. The exit of this mode is automatic if the learning is not successful at the end of 15
seconds.
•
Send the infra-red code of your remote control in direction of Vimaty's infrared receiver on the
center of the bottom of the Vimaty70(the remote must be between 20 and 50 cm far away of
the infrared receiver to allows good infrared learning).
•
The buzzer is activated when the code was learned and the message "IR Code Learned"
appears in the bottom of the screen.
•
In the learning mode, the touch screen is inactive. To force the exit of the learning mode, it is
necessary to press one of the buttons.
•
If the learning did not function with your remote control, choose the mode "Forced" and starts
again the operation. (the forced mode seizes the infra-red data without controls)
5.2.2 - Upadte IR code with CompactFlash
The PC2Maty software associated with the infra-red data base in Ir dump can avoid you the
tiresome work of infra-red learning . It is enough for you to declare the type of devices and the
function necessary for the infra-red codes and PC2Maty generates automatically during the
compilation of your project, an infra-red data file for your application in the CompactFlash.
To update infra-red data on Vimaty, it is necessary to click on the button called “Load IR
codes”, or touch simultaneously the screen and the push button on the center of the left side of
the screen.
15/33