Moster 185 Plus - Maintenance manual - V1
117
Insert the cylinder (5).
Add copper paste to the nuts.
Place the head (3) on the cylinder (5) and the 4 self-locking nuts M8 (1) with washers (2).
Tighten the nuts progressively, then cross-tighten with the torque shown in the figure.
Check the squish measurement on the pin axis: acceptable values range
from 1,35 mm to
1,55 mm.
If the squish is out of tolerance, increase or decrease the thickness of the cylinder base gasket
until the required result is obtained.
16 Nm