Vitroceramic KHC 601 M, Instructions For Use - Installation Advice

Page: 17 / 20

17
CONNECTION OF THE POwER SuPPLY
CABLE
The power supply cable must be connected by
a suitably qualified person in order to avoid a
hazard.
To connect the feeder cable to the hob it is necessary
to carry out the following operations:
Unscrew the screw “
•
A ” of the terminal board at
the bottom of the hob (fig. 5.1).
Unlock the 2 clips “
•
B ” and open the cover “ C ”.
Unscrew the screw “
•
D ” and open completely
the cable clamp “ E ” (fig. 5.3).
Position the
•
u bolts “ F ” onto terminal board “ G ”
(fig. 5.3) according to the diagram in fig. 5.2.
Connect the phase, neutral and earth wires to terminal board “
•
G ” according to the
diagram in figs. 5.2 and 5.3.
Strain the feeder cable and block it with cable clamp “
•
E ” (by screwing screw “ D ”).
Close the cover “
•
C ” of the terminal board “ G ” and block it with the screw “ A ”.
FEEDER CABLE SECTION
Type H05vv-F or H05v2v2-F or H05RR-F”
230 V ac 50 Hz 3 x 2,5 mm
2
(**)
(**) Connection with wall box connection.
Diversity factor applied. –
Diversity factor may be applied to the total –
loading of the appliance only by a suitably
qualified person.
Fig. 20
A
B
B
C
E
1
2
3
4
5
230 V
L N
Fig. 5.1
1
2
3 5
4
N
E
L
E
G
C
F
D
Fig. 5.3
Fig. 5.2