EN
21
Reset
/perform
Risk of injury around the columns during
reset
ƒKeep your distance from the table when adjusting the
height.
ƒDo not place any items under the table when adjusting the
height.
CAUTION!
!
Move your table downwards. Your table will stop automati-
cally just before the end position. (Table height 65 mm)Move
your table down again.
Once it has reached the end position (table height 64 mm),
the table will automatically shift back up slightly. The reset is
performed automatically.
If you remove your hand from the handset before the reset
has been carried out, the reset is interrupted and you must
repeat the procedure.
You will not be able to move your table up if the reset proce-
dure has been interrupted.
Reset
/to factory settings
(DPG1C02-000006)
Press at the same time for 8 seconds
After 5 seconds, the display will light up and show an arrow
with a countdown.
The light bar will flash red three times when the reset is com-
plete.
When you reset to factory settings, your DPG is returned to
its configurable state. This means that not all configurations
made in the DPG configurator will be reset, but only the set-
tings that were changed directly on the DPG (or in the app).
Troubleshooting
Errors
Cause
Solution
Motor,
control sys-
tem,
telescopic
guides
or
handset
does
not work.
Bad plug contact
Motor faulty
Control system
faulty
Handset faulty
Feed cable faulty
Contact your Vitra
retail partner.
Your
table
cannot
move
up/down.
Power failure
1. Unplug the power
cable for 1-2 seconds.
2. Reset the unit.
Unit of measurement cm/inch change
(DPG1C02-000006)
If the height shown on the display is not correct, it can be
adjusted.
Press at the same time for 5 seconds
-display height flashes and
displays cm or inch
Press the handset once to change the unit.
Press any button to confirm the height or wait 10 seconds.
Confirmation is automatic.
Summary of Contents for Tyde 2
Page 15: ... ...
