VSC8211 Evaluation Board
User Guide
Revision 1.0
December 2013
Vitesse Proprietary
Page 9 of 13
•
Windows 2000
•
Windows XP
•
Windows Vista
•
Windows-7
Note
The GUI may be slower when run on Windows 2000 operating system.
2.
Hardware requirements must be considered when deploying/installing .NET
applications. The minimum hardware requirement for a system running a .NET
application is a Pentium 90MHz with 32 MB of RAM. For best performance, a
newer system is recommended along with a minimum of 1 GB of RAM.
3.
If the .NET Framework 2.0 is not already installed, it may be obtained from the
following link:
http://www.microsoft.com/downloads/details.aspx?FamilyID=0856EACB-4362-
4B0D-8EDD-AAB15C5E04F5&displaylang=en
3
Quick Start
3.1
Board Configuration
Prior to powering the board, ensure that the jumpers and switches are in the following
positions.
Table 1.
Switch and Jumper Configuration
Switch/Jumper
Position
J23 (MDC)
Jumper installed connecting DUT MDC to F340 SCL
NOTE
: This is due to a layout error on the PCB. Refer
to Section 2.1.9 for additional details.
J23 (MDIO)
Jumper installed connecting DUT MDIO to F340 SDA
NOTE
: This is due to a layout error on the PCB. Refer
to Section 2.1.9 for additional details.
J15 (TRSTB)
Jumper installed connecting to GND. This is not
required when R35 is installed.
J13 (XTAL1/REFCLK)
Jumper installed connecting center pin to XTAL.
J8 (PLL ENABLE/DISABLE)
Jumper installed connecting center pin to PLL ENABLE.
SW1
Hold in the left position during power-up and reset.
3.1.1
Power Up
P5VDC to the board by plugging in the power cable (included in the kit) to
J24. Two green LEDs should illuminate: D12 on the left side of the board indicating
+3.3VDC present, and D14 indi1.2VDC present.