P/5
P/6
Trimmer
Clean the trimmer each time after use.
1. Cut off the power supply of the shaver, then unplug the charger and also
pull out the product's plug from the shaver.
2. Clean the trimmer with the brush (Fig 15).
3. Lubricate the trimmer teeth with a drop of sewing machine oil once every
six months (Fig 16).
Change
Change the shaver head once a year to get the best shaving effect. The
shaver has a long service life if not damaged for human factors.
1. Cut off the power supply of the shaver, then unplug the charger and also
pull out the product's plug from the shaver.
2. Open the shaver head assembly.
Rotate the loosening button of shaver head counterclockwise by 60 to
unload the spacer. Unload the old shaver head then unload the fixed shelf.
3. Put the new one into the foil screen,
Align the shaver head with small holes to the center of foil screen and at the
same time make sure the shaver head accords with the shaver shaft. To load
the spacer, confirm that the shaver head aligns to the central shaft of foil
screen with small holes and then rotate the loosening button of shaver head
clockwise by 60. Make sure the marginal depression part of shaver head
assembly (foil screen) corresponds to the bulge of floating ring and the
bulge of shaver head is inserted into the depression part on the center of foil
screen.
4. Close the shaver head part.
Accessories
The following accessories are included with the product: Charger; Brush;
Attractive Pouch.
Environmental Protection
1. To discard the product, please don't put it together with general domestic
rubbish heaps but hand it to the officially designated recycle center for
the environmental protection.
2. The built-in rechargeable battery contains substances which may pollute
the environment, so it must be unloaded from the product or sent to the
officially designated recycle center to be disposed before it is discarded.
The battery should not be unloaded unless it has been used up.
1. Unplug the charger and also pull out the product's plug from the shaver.
2. Get the shaver to keep running until it stops; then screw off the bolt and
open the shaver (Fig 20)
3. Unload the battery. Do not plug in the Shaver again after unloading the
battery.
