5
5. Installation Instructions
•
Make sure the power is not applied before installation.
•
Once the camera is installed, you must first connect the low voltage (AC24V or DC12V). Then, plug the
AC adapter into the AC outlets to avoid an improper reset and damage from a possible surge voltage.
5.1. Mounting the camera on the wall
1) Drill 4 holes into the wall or ceiling using the supplied
template
2) Insert the anchors into the drilled holes
3) Match
(
foot mount holes) to the drilled holes
4) Affix the mounting bracket by using supplied screws
5.2. Power Supply Connections
The VTC-IRE70/650 can operate with either 24AC or 12VDC, dual voltage power.
It is required that the polarity-matched connection is made for 12VDC supply, otherwise IR LEDs,
will not operate at night.
Primary and secondary grounds are completely isolated to avoid possible ground-loop problems.
6. SETUP Menu
6.1 In the Menu
The setup menu can be accessed and controlled with the OSD joy stick on the side of camera.
Five commands are available with the joy stick.
In the menu,
use
▲
,
▼
to move menu, , to change the settings and press
●
to select or enter.
Clamp connectors of power input
AC24V/DC12V (RED WIRE)
AC24V/GND (BLACK WIRE)
Joy stick
VIDEO
SUB-OUT
connector
SYMBOL descriptions for joystick operation
1.
▲
,
▼
, , - Denotes the direction of
Joystick lever operation.
2.
●
- Denotes “ENTER” by pressing
straight down on the Joystick lever
