PORTABLE CD/MP3 PLAYER
WITH USB/MMC SLOT
Before using the device, please, read these
instructions attentively.
FUNCTIONS AND CONTROL
1. CD compartment door
2. NEXT/SEARCH FORWARD button
3. PLAY MODE button
4. PLAY/PAUSE button
5. ASP/DIR/NEXT button
6. PROGRAM button
7. Accumulator batteries compartment
8. LED Display
9. STOP/FUNCTION button (power off)
10. PREVIOUS/SEARCH BACKWARD button
11. Headphones jack
12. Battery charge indicator
13. CD door open button
14. Volume control
15. Linear output jack
16. Battery charge switch
17. Bass boost switch
18. Control buttons locking switch
19. Power adapter jack
20. USB jack
21. SD/MMC memory cards jack
POWER
Power supply from the power adapter (sup?
plied with the device)
1. Insert the plug end of the power adapter
cord into the power adapter jack (19).
2. Connect the power adapter to AC 220?
230V ~ 50 Hz power outlet.
Note:
• If batteries are installed inside the device
when connecting the power adapter, the
device will automatically switch to the AC
power (adapter).
• Use only the adapter included with the
player. Using other adapters can dam"
age the device.
• Before connecting make sure that the
adapter operating voltage corresponds
to the voltage of the local power network.
• When there is no power in your supply
network, disconnect the power adapter
from the outlet.
• Don't touch the adapter with wet hands.
Power supply from batteries
1. Disconnect the power adapter both from
the AC outlet and the player.
2. Open the battery compartment.
3. Insert two Ni?MH batteries (1.2V
1200mA/h) (supplied with the device),
observing their polarity.
4. Close the battery compartment door.
5. Set the battery charge switch to the ON
position to start charging, the red
CHARGE indicator will light up.
ATTENTION:
to prevent damaging the
device and batteries, the duration of one
charging cycle should not exceed 12 hours.
CAUTION:
• Do not use (Ni?MH) and usual (for exam?
ple, zinc?carbon) batteries simultane?
ously.
• Do not charge the batteries for more than
12 hours.
Note:
• When batteries are charged for the first
time, 15 hours are needed to fully charge
them.
• If the batteries operation time has con"
siderably reduced, even when charged
properly, buy a new set of batteries.
CONNECTION
Connection to audio system
Connect the stereo cable (not included with
the device) to the linear output jack LINE
OUT (15) and to the audio system jack
CD/AUX.
ENGLISH
4
3790.qxd 15.08.05 17:15 Page 4
