Vitek VT-TPTZ10HR-2T, Manual

Page: 10 / 28

Transcendent Series 2.1 MegaPixel 10x HD-TVI PTZ Camera
10
b. As shown in Fig 13, at first unscrew the M4 screw at the side of the base of ceiling and split the
base of ceiling and boom. Then make the three groups of cables of power, video/control and
alarming into the side recessing seal groove of the ceiling connector bottom and through the core
hole of the base of ceiling mounted. Fix the base of hang ceiling on the ceiling board.
Fig 13
Note : If the dome is used in the outdoor conditions, use the silica gel on the faying surface of the
base of hang ceiling and the ceiling board and around the out-holes to be sure water proof
c. As shown in the Fig 14, tighten the boom with electrical wire and cable through it on the base of
ceiling and screw up the M4 screw.
Fig 14
Note : If the dome is used in the outdoor conditions, after using enough raw materials to wrap the
thread at the upper end of boom, tighten the boom on the base of ceiling. Use the silica gel around
the joint sleeve and connector of the boom to be sure water proof