6
ENGLISH
•
Put the unit on the safety stand (8) on a flat heat-resistant
surface and let it heat up (approximately 2-3 minutes).
Use the display (3) to control the heating temperature.
•
Take a hair lock with the free hand.
•
Press the clamp handle (4), place the end of the lock on
the operating surface (7) and move the clamp (5) down.
Wind the lock around the operating surface.
•
Wait for a while, then press the clamp handle (4) and
release the hair lock.
•
Repeat this procedure on the rest of your hair.
Note:
– Do not touch the operating surface during the unit opera-
tion.
– If during 60 seconds the buttons (9) are not pressed, the
unit will be automatically switched off.
– During the first operation some foreign smell and a small
amount of smoke from the operating surface are possible,
this is normal.
– During breaks in operation, place the unit on a flat heat-
resistant surface.
– Do not comb your hair right after styling, let it cool off.
– Divide big locks into smaller ones carefully to make the
hairstyle look natural.
•
After you finish curling your hair, switch the unit off by
pressing and holding the button (2) for 2-3 seconds, the
display (3) will go out.
•
Remove the power plug from the mains socket.
•
Put the unit on the safety stand (8) and let it cool down
completely.
CLEANING AND CARE
•
Before cleaning unplug the unit and let it cool down com-
pletely.
•
Do not immerse the unit, the power cord and the power
plug of the unit into water or other liquids.
•
Do not use detergents, abrasives, and any solvents to
clean the unit.
•
Clean the unit body with a soft, slightly damp cloth and
then wipe it dry.
STORAGE
•
Let the unit cool down completely and clean it before tak-
ing away for storage.
•
Never wind the power cord around the unit body as this
can damage the cord.
VT-8420.indd 6
4/19/18 2:42 PM
