Vitek VT-8235 VT, Manual

Page: 4 / 27

ENGLISH
5
to keep it for at least two hours at
room temperature before switch-
ing on.
•
Unpack the unit completely and
remove any stickers that can pre-
vent unit operation.
•
Check the unit for damages, do not
use it in case of damages.
•
Before switching the unit on, make
sure that your home mains voltage
corresponds to the unit operating
voltage.
USAGE
•
Install one of the attachments
(7 or 8) on the unit body (4) so
the symbol «
p
» on the unit body is
above the symbol «

» on the select-
ed attachment. To fix the attach-
ment rotate it clockwise, the sym-
bols «
 » « p » on the unit body and
the attachment should match. If the
attachment is set properly, you will
hear the release button (5) click.
•
To remove the attachment, press
the release button (5) and turn the
attachment counterclockwise.
•
Insert the power plug into the mains
socket.
•
Make sure that the switch (2) is in
the lower position «0».
•
Select the operation mode using
the switch (2):
«0» – the unit is off;
«
 » – «cool» shot mode;
«1» – low air flow speed;
«2» – high air flow speed.
Note:
During the first operation some for-
eign smell and a small amount of
smoke from the heating element is
possible, this is normal.
•
Fix the lock end on the attachment
(7 or 8).
•
Dry your hair for some time
(depending on your hair type), con-
trolling the temperature and inten-
sity of the air flow with the operation
mode switch (2).
•
To fix the lock set the operation
mode switch (2) to the position «
 »
or press the button (3) «COOL», the
air flow temperature will decrease
that helps to fix the styled lock.
•
Repeat the styling procedure on the
rest of your hair.
•
Hair spray should be applied only
after hair styling is finished.
•
After the hot air styler operation is
finished, switch it off by setting the
switch (2) to the «0» position and
unplug it.
•
Place the unit on a flat heat-resis-
tant surface and let it cool down
completely.
Notes:
During breaks in operation place
the unit on a flat heat-resistant sur-
face.
Avoid contact of heated surfaces
of the unit with your face, neck and
other open parts of your body.
Do not comb your hair right after
styling, let it cool off. Carefully
divide the locks with your fingers to
make the hair style look naturally.
Do not block the air inlet grid during
the use of the hot air styler.
Avoid getting of hair into the air inlet
grid during operation of the unit.
VT-8235_105 x148.indd 5 22.03.2016 10:28:38