Vitek VT-8235 VT, Manual

Page: 2 / 27

ENGLISH
3
HOT AIR STYLER VT-8235 VT
The hot air styler is used for styling dry
or slightly wet hair.
DESCRIPTION
1. «Cool» shot button
2. Operation mode switch
3. Hanging loop
4. Body
5. Attachment release button
6. Attachment installation place
7. Thermal brush
Ø
40 mm
8. Flat brush
ATTENTION!
•
Do not use the unit near containers
filled with water (such as swimming
pool etc.).
•
After using the unit in a bathroom,
unplug it by taking the power plug
out of the mains socket, as close-
ness of water is dangerous even if
the unit is switched off.
•
For additional protection you can
install a residual current device
(RCD) with nominal operation cur-
rent not exceeding 30 mA into the
bathroom mains; contact a special-
ist for installation.
SAFETY MEASURES
Before using the unit, read this instruc-
tion manual carefully and keep it for
further reference.
Use the unit according to its intended
purpose only, as it is stated in this
user manual. Mishandling the unit
can lead to its breakage and cause
harm to the user or damage to his/
her property.
To avoid the risk of electric shock,
observe the following safety mea-
sures.
•
Before switching the unit on, make
sure that your home mains voltage
corresponds to the unit operating
voltage.
•
Do not switch the unit on in places
where aerosols are sprayed or high-
ly inflammable liquids are used.
•
Hair spray should be applied only
after hair styling is finished.
•
It is recommended to unwind the
power cord to its full length while
using the unit.
•
The power cord should not:
–
touch hot objects,
– be immersed into water,
–
run over sharp edges of furni-
ture,
– be used as a handle for carry-
ing the unit.
•
Do not touch the unit, the power
cord and the power plug with wet
hands.
•
Check integrity of the power cord
periodically.
•
Never use the unit if the power cord
or plug is damaged, if the unit works
improperly or after it was dropped.
Contact an authorized service cen-
ter for all repair issues.
•
Do not use the unit while taking
a bath.
•
Do not put or keep the unit in places
where it can fall into a bath or a sink
filled with water; do not immerse
the unit body, the power cord and
the power plug into water or any
other liquids.
VT-8235_105 x148.indd 3 22.03.2016 10:28:38