3
NOTES
• Please read these instructions carefully before using the product and keep this for future reference.
• All the examples and pictures used here are for reference only.
• The contents of this manual are subject to change without notice.
• This device should be operated only from the type of power source indicated on the label. Also, verify
the voltage.
•
PLEASE CHECK
the device and accessories upon purchase. If there is any damage, shortages or
defects, please contact your VITEK Reseller immediately.
HDD INSTALLATION
• This Network Video Recorder supports 1 SATA hard drive.
• Please make sure that the device is powered off before installation. The pictures of the installation
are for reference only. In the event of a discrepancy, refer to the actual product.
①
Loosen the screws to open the cover.
②
Insert the screws into the HDD but do not tighten them.
③
Place the HDD onto the bottom of the recorder.
④
Turn over the machine and secure the HDD with included screws.
⑤
Connect the power and data cables.
⑥
Re-install the cover and secure it with the screws.
Tip: Please check the inside structure of the device and make sure the cables are well connected
before re-installing the cover.
REAR PANEL INSTRUCTION
*Product ports and rear panel features table on following page
START-UP AND SHUTDOWN
►
Startup
①
Connect the monitor and the power.
②
The device will boot and the power indicator will display in blue.
③
A wizard window will pop up.
► Shutdown
Click “Start” and select the “Shutdown” icon. This will bring up a shutdown window.
The device will shut down by clicking the “OK” button. Then disconnect the power.
LOGIN
You must configure the wizard when you start the NVR for the first time. Choose the
language and read the privacy statement. Then set the data, time and zone as needed.
After that, set the login password.
The default username is ‘admin’ and the default password is 123456. Set your own
password or use the default one when you use the wizard for the first time. Enable
pattern lock and click “Edit” to set the pattern lock. Then set the security
questions and answers. It is important for you to remember these answers, or you
will not be able to reset your password. Click “Next” to continue.