2
3
NOTES
• Please read these instructions carefully before using the product and keep this for future reference.
• All the examples and pictures used here are for reference only.
• The contents of this manual are subject to change without notice.
• This device should be operated only from the type of power source indicated on the label. Also, verify
the voltage.
•
PLEASE CHECK
the device and accessories upon purchase. If there is any damage, shortages or
defects, please contact your VITEK Reseller immediately.
HDD INSTALLATION
• This Network Video Recorder supports 1 SATA hard drive.
• Please make sure that the device is powered off before installation. The pictures of the installation
are for reference only. In the event of a discrepancy, refer to the actual product.
①
Loosen the screws to open the cover.
②
Insert the screws into the HDD but do not tighten them.
③
Place the HDD onto the bottom of the recorder.
④
Turn over the machine and secure the HDD with included screws.
⑤
Connect the power and data cables.
⑥
Re-install the cover and secure it with the screws.
Tip: Please check the inside structure of the device and make sure the cables are well connected
before re-installing the cover.
REAR PANEL INSTRUCTION
*Product ports and rear panel features table on following page
