8
PROGRAMMING
Programming your Machine with a
Custom Chip
1.
Turn on the machine.
2.
Remove the container and rotate the machine to the rear
so that you can see the programming port.
3.
With the rear of the machine facing towards you, insert
the custom programmed chip (with the words, “THIS SIDE
FACING TO THE FRONT OF THE MACHINE” toward the
left) into the port located on the right hand side of the
machine opposite the On/Off switch. Push gently until chip
engages into the port. The display window will read “New
Module.”
4.
Within 10 seconds, the six Pre-Set buttons will be
re-programmed and the display window will read “Saved”
then “Ready.”
5.
Remove the programming chip, return it to the original
package and store in a safe, easily accessible spot.
6.
Press one of the six Pre-Set buttons to reveal, in the display
window, the name of the program/drink.
Resetting the Pre-Set Buttons to the original factory settings
1.
Access the Owner Controls by activating the power switch located on
the back of the motor base while depressing button 2.
2.
Once the unit powers up, it will cycle through three screens then stop on the motor
status screen. Depress button 2 again, within 12 seconds, to scroll through the
menu settings.
3.
Scroll using button 2. The screen will display “1 TO OVERWRITE CURRENT PROGRAM”.
Depress button 1 to reset to the original factory settings.
IMPORTANT NOTES!
Programming Chip:
If the above programming steps are taken and the custom
programming does not appear with the first blend cycle, turn the chip 180˚
(side-to-side) and try again.
