Vital CNC Control User Guide
© 2014 Vital Systems, Inc.
8
Drive Connection with Maxsine AC Servo Drives and 7736 Board
AC Servo Motor and Drive Packages purchased from the Vital Systems website come with additional
components, for a simple and quick plug-and-play wiring setup.
Said components are:
-
1x Drive Interface Board (EPx-DIB) plugs on the servo drive
-
1x Blue RJ45 Drive cable
-
1x Green RJ45 Encoder cable
-
7736 Differential Encoder and StepGen Board
NOTE: the 7736 board works with both DSPMC and HiCON Integra motion controllers. However, this is
only used for the Step/Dir Outputs with the DSPMC.
Setting up the drive connection is simply a matter of plugging the colored cables to the corresponding
colored and labeled RJ45 Ports on the 7736 board and the Drive Interface Board.
The Blue RJ45 cables connect to the drive ports while the green cables connect to the encoder ports.
Connection on 7736 Differential Encoder and StepGen
Board
connection method.
link: http://www.youtube.com/watch?v=xDHRH0ZVeow
Connection on Maxsine AC Servo Drives
WARNING:
NEVER interchange the Blue Drive cables with the
Green Encoder cables. Doing so may damage your drives and the
Vital CNC Control.
