- 11 -
SENSATIONS
When VITAFON-
Т
is in work, sensations are generally absent or there is a pleasant
feeling of warmth or vibration.
Where a nerve center becomes involved, a painful sensation may sometimes appear,
which enables the organism to react to its internal disorders in a more adequate way (the
pain will subside soon). If the pain persists for 2-3 days, one should discontinue
treatment and consult with a doctor.
In case of a chronic disease, an aggravation of pain usually occurs during the first 5-
10 days of treatment. This pain gradually subsides by the end of the course of treatment.
In the case of a severe disease, pain may disappear only during the second course of
treatment.
APPLICATION OF VIBROPHONES
Vibrophones should be applied directly to the patient’s body. Membrane surfaces are
to be applied to the body covered with a gauze, paper or cotton towel (for hygienic
reasons). All converters should be fixed with an elastic bandage, special fixing
equipment (e.g. fixation glands) for the apparatuses of the VITAFON -family or can be
simply supported by hands or presses by a patient’s body. Membrane and converters
surfaces should be applied closer to the body. The maximum sensation of vibration at the
low frequency range may serve as a criterion of the right application. It is not advisable
to press converters with a too much effort, because it will result in the cessation of
microvibration and, consequently, of the healing effect.
Converters can be placed at any distance from each other (if there is no special note
in the treatment scheme) within one plane or at any angle. The only rule one should obey
is not to place vibrophones with their membranes towards each other if the distance
between then is less than 10 cm. – in such a position mutual energy termination takes
place and healing effect decreases.
In the case of treatment of joints and in some other cases it is recommended to place
vibrophones on the angle of 90
o
to each other with the membranes facing each other (see
picture 2). In this position the maximum effect is achieved at the point of intersection of
vibrophones’ axes.
Picture 2. Location of vibrophones on the angle of 90
o
to each other
90
о
