vita vPad excellence, Instructions For Use Manual

Page: 56 / 72

2 1 3
56
6. Button management
7. Firing window
8. Technical data / information
7.2 Firing program: pressing curve
Note:
• Modified parameters will affect the active firing process. If you want to make permanent changes to the firing programs,
you will need to save them.
• Night mode: Pressing the button activates the night program, i.e., after a firing program runs, the lift moves back in after the
firing chamber temperatures sinks to 200 °C, and the display and heating are switched off. To switch the device back on,
switch the main switch off and then on again. Night mode must be activated before starting a firing program.
• All buttons (except for Start temperature, Pressing time / pressure 1, Pressing time / pressure 2) are described under 7.1.
• The main vacuum cannot be altered in the pressing program. The vacuum is controlled automatically throughout the entire
pressing time.
• If the furnace is connected individually, the firing program overview opens after briefly tapping the firing program.
• If several furnaces are connected, the multi-furnace selection opens after the selection of the firing program.
• In the multi-furnace selection, the firing program is set to the first furnace available for this type of firing.
•
If another furnace is to be used, hold down the firing program and move it to the next available furnace.
• Now briefly tap the firing program, and the firing window will open.
Briefly press firing program to go
to the firing window. Multifurnace: Press and hold the firing
program button to move it if you want
to use another firing device. Select pressing program.
Rise time/gradient
Pressing time
and pressing
pressure 1 Firing temperature
and holding time
Pressing time and
pressing pressure 2
Main vacuum
Assistance function
Start temperature
Current firing chamber
temperature
Cooling temperature/
cooling time
Cooling lift position
Back
Firing program time
Process data Night mode Save Start/stop program