FIGURE B
Two-Piece Lid
48 oz. / 1.4 Ltr. Xtreme Performance (XP)
Container
The two-piece lid is easy to clean and easy to put on,
take off and seal.
• To remove a fully latched lid, lift the two tabs
and pull upward and off.
• Twist the center lid plug to fasten or remove.
One-Piece Lid
(optional)
48 oz. / 1.4 Ltr. Xtreme Performance (XP)
Container
The one-piece lid is easy to clean and easy to put on,
take off and seal.
• There is no lid plug for this lid.
• Add ingredients through port on top.
Lift lid tabs
to remove lid
To secure lid plug, rotate it so one tab locks
between the notches on top of rubber lid
FIGURE A
Compact Cover
Cover Door:
1. The Cover Door can be removed by opening it until
the door is horizontal. Then, gently spread the
sides of the door over the round hinges
and remove.
2. To reinstall the Cover Door,
gently spread the sides of
the door and place the door
hinge cutouts over the
round hinges.
Back Cover:
1. To remove the Back Cover from the Blending Station:
a. First remove the Cover Door from the unit as described above.
b. Remove the two (2) Back Cover mounting screws from
the rear of the machine (see Figure D).
c. From the rear of the machine, firmly push the bottom of
the cover forward (towards the Control Panel), keeping
the bottom edge of the cover against the Motor Base.
DO NOT tilt or strike the cover during removal.
d. Slide forward until the side latches on the front of the
cover are released from the Motor Base (see Figure E).
DO NOT strike the cover to "pop" the side latches
from their tracks. Doing so will cause damage. The
cover must only be removed by sliding it forward
(towards the Control Panel).
2. To replace the Back Cover on the Blending Station:
a. Place the Back Cover on the Motor Base approximately
1 inch / 2.4 cm forward of its normal position.
b. Slide the cover towards the back of the machine (away
from the Control Panel).
Make sure the side latches
slide into their tracks.
c. Push until back of cover is seated against the Motor Base
(see Figure F).
Make sure the Back Cover is fully
seated in the back and the side latches are in their
grooves before inserting and tightening the
mounting screws.
d. Replace and firmly hand-tighten the two (2) Back Cover
mounting screws (see Figure D).
DO NOT over-tighten
or use any tools to tighten. DO NOT use the
mounting screws to pull the Back Cover into
position. Doing so will cause damage.
FIGURE D
FIGURE C
FIGURE E
FIGURE F
Containers:
• Blending Station Advance machines are optimized for use with the Vita-Mix 48 oz. / 1.4 Ltr.
Xtreme
Performance (XP)
container. Use of Vita-Mix Standard containers (48 oz. / 1.4 Ltr. or compact
32 oz. / 0.9 Ltr.) may require programming adjustments. The 48 oz. / 1.4 Ltr. Xtreme Performance
(XP) container
may not
work with earlier Vita-Mix models. The 64 oz. / 2.0 Ltr. standard container
will not
fit in the compact cover used on the Blending Station Advance. Call Vita-Mix Customer
Service or your distributor for more information.
• Outside the United States and Canada, your machine may come with a different container
configuration.
New Lids:
To make new lids easier to insert and remove, rub a light coating of cooking oil around
rim where it seals. Place it in container for several minutes, remove and lightly wipe oil off lid.
IMPORTANT NOTES!
7
6
