www.vistacnc.com
- 11 -
www.vistacnc.com
- 11 -
iMach
III
P2-S Pendant Manual v. 4.0.0
5.2
E-Stop switch button in P2-SE model
Press E-STOP switch button to send out E-Stop signal to Mach3 application and activate
Emergency Mode in Mach3.
The same E-stop signal is simultaneously sent out through a 2-wire loop, which can be used to
control a relay or to connect with other E-stop buttons.
When the button is pressed and the switch is locked down, the 2-wire loop is open.
Twist the button to reset the switch
and reset E-STOP signal, and at the same time, the two
wires are connected at the switch end and form a closed loop.
A EE box is needed as an interface to separate the 2-wire loop and USB signal.
E-STOP switch and EE box connection in P2-SE
