VK2-1080BIR35V16e User manual V1.0
13
3.2. Access from the internet
Access from the internet once connected, the VK2-1080BIR35V16e is accessible on your local
network (LAN). To access the VK2-1080BIR35V16e from the Internet you must configure your
broadband router to allow incoming data traffic to the network camera. To do this, enable the NAT-
traversal feature, which will attempt to automatically configure the router to allow access to the
network camera. This is enabled from Setup > System > Network > NAT.
For more information, please see
“3.5.6 System>Network>NAT” of User’s Manual.
3.3 Setting the admin password over a secure connection
To gain access to the product, the password for
the default administrator user must be set. This is
done in the “Admin Password” dialog, which is
displayed when the VK2-1080BIR35V16e is
accessed for the setup at the first time. Enter
your admin name and password, set by the
administrator.
Note: The default administrator username is
admin and password is admin. If the password is
lost, the VK2-1080BIR35V16e must be reset to
the factory default settings. See
“3.8 Resetting to
the Factory Default Settings”.
To prevent network eavesdropping when setting the admin password, this can be done via an
encrypted HTTPS connection, which requires an HTTPS certificate (see note below).
To set the password via a standard HTTP connection, enter it directly in the first dialog shown below.
To set the password via an encrypted HTTPS connection, see
“3.5.6 System >Security>HTTPS”.
Note:
HTTPS (Hypertext Transfer Protocol over SSL) is a protocol used to encrypt the traffic between
web browsers and servers. The HTTPS certificate controls the encrypted exchange of information.
