37
QNVR Installation Manual V1.1
QNVR installation and user manual
2-8. Motion
Motion on any channel can trigger recording of that camera.
This configures the various recording settings per channel in the motion record mode.
The stream, audio are set up in the same way as the normal and alarm recording mode.
Sensitivity
The sensitivity of motion detection, there are 10 levels ranging from 1(low) to 10(highest).
It is recommended that each level is tested to find out which one suits that particular camera
site. The motion detection is not recommended for external cameras.
Post Duration
This allows you to set the time in seconds to post-record after the actual motion recording
has ended. Up to 99 seconds can be set.
Setting the motion detection area
Note: this sets a detection zone in the camera. (Not the NVR)
To setup the motion detection area per channel, click
the “Set” button.
The motion detection area allows you to
highlight areas where you would like
motion to be detected in. To create an
area, left click the mouse, hold and drag it
to create the motion detection area.
Click the right button on the mouse, the
pop-up menu appears.