33
QNVR Installation Manual V1.1
QNVR installation and user manual
3. Check IP Camera > Basic > Alarm
= Stream 1
4. Set IP Camera > Basic > Schedule = AL+M+N1
If Live viewing is to be done in a lower resolution, check that IP Camera > Basic > Live
stream is set to Stream 3.
2.4 Stream Switching record setup
2.4.1 Camera set up for Stream Switching record mode
It is necessary to configure both Streams 1 and 3 in order to be able to operate in this mode.
To do this use the SmartManager utility supplied with the VK2 cameras to set up the both
streams by completing the following steps:
1. Set Stream 1 to be the Event rate stream, normally the higher resolution / higher frame
rate setting.
2. Set the resolution of Stream
2
to the desired resolution of the Non-Event stream. (All other
Stream 2 parameters are not relevant)
3. Set Stream 3 resolution to “Follow Stream 2”
4. Set the required Bit rate and Frame rate for stream 3
5. Next set up the event type in the camera that will cause the stream switching, this can be
one of various types such as: hard wired alarm input, motion detection, or a software
trigger. Use the Smart Manager utility supplied with the camera.
2.4.2 QNVR set up for Stream switching record mode
Once the camera’s stream parameters and event options have been set, and the cameras
have been discovered by the QNVR, the QNVR must be set to record in the desired way. For
Stream Switching recording, the following steps should be made:
1. Set IP Camera > Basic > Normal (TL) = Stream 3
2. Set IP Camera > Basic > Motion
= Stream 1
3. Set IP Camera > Basic > Alarm
= Stream 1
4. Set IP Camera > Basic > Schedule = AL+M+N1
