www.vistacnc.com
- 11 -
www.vistacnc.com
- 11 -
iMach
III
P4 Pendant Manual v. 3.4
•
Number in
Step Jogging
FeedRate
is the feed rate only used in MPG step jogging. When
MPG wheel stops, the feed rate and FeedRate Overridden rate (FRO) automatically changes
back to the number which was used before MPG moving. Set 0 to use current FeedRate and
FRO rate in the system.
•
Numbers in
Speed Change Sensitivity
is used to adjust the sensitivity of V mode. The smaller
the number, the less turns are needed to reach maximum axis speed.
•
Steps to Delay Start
is used to set the number of steps to delay to start axis movement. In C
mode, axis starts to move only after that many numbers of steps are turned from MPG wheel.
•
Velocity In’s or mm’s Per min.
is used to calculate feed rate used in STEP jogging in CON’T /
STEP mode. The number can be copied from Mach3 -> Config -> Motor Tuning, and the
number need to be refreshed each time motor turning is performed.
•
F1 to F5 buttons each has 62 functions to select:
