QR813 10
ENGLISH
Installation
ATTACHING THE SUPPORT BRACKETS
-
Use appropriate hardware to fasten the supplied support
brackets to your wall .
-
If fastening hardware supplied with this range hood is
appropriate for your wall type, enlarge the pilot holes using
a 1/4 in . (6 mm) drill bit . Install the plastic wall anchors
(CC) and fasten the brackets using the supplied tapping
screws (AA) .
INSTALLING THE DAMPER
WARNING:
Sharp edges . Wear safety gloves .
CAUTION:
Be very careful when installing the damper .
Applying too much force or bending the damper too much
may damage or break the damper hinge ends .
-
Insert one end of the damper (3) into the hinge slot (4) at
the top of the range hood (A) .
-
Gently bend the damper (3) and insert its other end into the
hinge slot (4) .
WARNING:
For drywall or plaster walls, support bracket
(D) should be secured to wooden wall studs or a support
structure directly (without supplied anchors (CC)) or using
fastening hardware appropriate for your wall type .
Fig. 6
CC
D
A
3
4
3
Fig. 7
INSTALLING THE RANGE HOOD
CAUTION:
Make sure the range hood is secure before
releasing it .
-
Hang the range hood on the range hood support bracket (D)
and mark the locations of the two mounting holes inside the
range hood . Take the range hood off the wall and drill two
pilot holes in the marked locations .
-
If fastening hardware supplied with this range hood is
appropriate for your wall type, enlarge the pilot holes using a
1/4 in . (6 mm) drill bit and install the plastic wall anchors (CC) .
Lastly, hang the range hood back on the range hood support
bracket (D) and secure to the wall with two tapping screws
(AA) .
Fig. 8
CC
D
AA
