Quick User Guide to Main Alarm Control Operations by KP-250 PG2 Keypad
The Quick Start Guide is intended for the user of the system. Please remove
this detachable sheet and hand it to the user.
Arming and Disarming the System
Step
Operation
User Actions
Key & Keypad
Response
O
pt
iona
l
1
Press the Partition Selection
button and then select a
PARTITION
(if Partition is enabled)
followed by any combination of
The selected key blinks.
2
Arm AWAY
+ [
] or enter code
The selected key and the
"Present Prox Tag" LED (
) begin to blink and
prompt you to present
your Tag or enter your
user code.
The keypad's LED blinks
red once to indicate
transmission of the
arming command to the
control panel.
The LED and the buzzer
then indicate the control
panel's response – refer
to the KP-250 PG2
User’s Guide, Chapter 4
“System Status and
Indications”.
Arm HOME
+ [
] or enter code
Disarm (OFF)
+ [
]
or enter code
O
pt
iona
l
Quick arm AWAY
(If Quick Arm is enabled)
Quick arm HOME
(If Quick Arm is enabled)
Forced arming AWAY
(system not ready)
+ [
] or enter code
to silence the “protest” buzzer
Forced arming HOME
(system not ready)
+ [
] or enter code
to silence the “protest” buzzer
O
pt
iona
l
3
INSTANT
(After arming HOME/AWAY)
LATCHKEY
Note: The factory default master user code is 1111. The code is not required if quick arming has been permitted by the
installer. Change the factory default code to a secret code without delay (refer to the KP-250 PG2 User’s Guide,
Chapter 6, section B.4).
Initiating Alarms
Alarms
Actions
Notes
Emergency alarm
(
≈
2 sec.)
When pressing the Fire or Emergency icons, the KP-250
PG2 starts beeping. After pressing the button for approx. 2
seconds, the KP-250 PG2 sends the command.
Fire alarm
(
≈
2 sec.)
Panic alarm
(
≈
2 sec.)
