2
D-303404 GSD-442 PG2 Installation Instructions
2.3 Inserting Battery
9 volts
1
A
C
B
D
Insert battery (see figure 3).
1.
Open the battery cover and connect the battery to its terminals without
the insulator. Verify proper polarity.
A.
Red button
B.
Battery connector
C.
Tab (1 of 4)
D.
Tamper switch actuator
Caution!
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the manufacturer's instructions.
Figure 3.
Detector Rear Side
3. INSTALLATION
3.1 Mounting
The detector can be mounted on a wall or ceiling. For EN approved sites, only ceiling installation is allowed.
It must be mounted with its bracket (when it is attached to its bracket the tamper switch is pressed and the detector automatic reset is
performed).
!
Warnings
Installation must be performed by a qualified individual. Failure to properly install, test and maintain a CO detector may cause it to fail,
resulting in loss of life!
Installation of the CO detector should not be used as a substitute for proper installation, use and maintenance of fuel burning
appliances, including appropriate ventilation and exhaust systems.
Unauthorized removal of the unit from the bracket will initiate a tamper alert!
!
Warning -
The battery must be inserted into the detector otherwise you will not be able to close the detector.
3.2 Diagnostic Test
For Diagnostics Test instructions refer to the control panel Installer Guide.
!
WARNING:
The test switch is the only proper way to test the CO detector. Never use vehicle exhaust! Exhaust may cause
permanent damage and void your warranty.
B. Communication Test
Create a tamper alarm at the installation location and verify that tamper message is received by the control panel / receiver.
1
2
3
UP
A
1.
Locate the bracket on the mounting surface so that the word
"UP" appears in the direction shown in Figure 4 (this ensures
that the text on the detector's stickers will be easily readable).
2.
Mark and drill 2 holes in the mounting surface. Fasten the
bracket to the mounting surface with 2 screws.
3.
Align the detector's tabs (see Figure 3) with the bracket slots
and rotate the detector as shown. Pull the detector outward to
verify that it is securely attached.
A.
Mounting Surface
Figure 4.
Mounting
4. MAINTENANCE
!
Warning:
Press the detector's TEST button once every week to ensure proper operation of the detector.
When low battery alarm exists (see specifications) immediately replace the battery (see figure 3).
Once a month, use a vacuum cleaner to clean the air vents occasionally, to keep them free of dust.
