Fon 0 93 64/81 76 00 - Fax 0 93 64/81 76 029 - [email protected] - www.visomax.de
6.5
Replacing support disc
Interrupt the air supply before you replace any accessories or wear parts. This preventive
measure prevents inadvertent start-up of the compressed air tool.
1
Fork wrench
2
Support disc
3
Washer
Remove the polishing pad.
Push the enclosed fork wrench (1) with the cropped side onto the hexagon nut under the
support disc (2) to fasten the drive shaft.
Turn the support disc (2) counter-clockwise off of the drive shaft. Remove the washer.
Remove dust and dirt, e.g. with a brush. Do not clean the device with compressed air.
Place the washer (3) on the new support disc (2).
Turn the support disc (2) onto the drive shaft clockwise. For this, fasten the drive shaft
with the fork wrench again.
Visomax Coating GmbH
- Sonnenstrasse 55 - D-97225 Zellingen
1
