11
3)
USB drivers are automatically installed.
Your measurements are not lost when updating to a newer version or uninstalling
and reinstalling. All measurements will always remain in your document folder. If
you want to remove all your measurements go to the ‘Light Inspector’ folder and
delete them manually.
Folder location:
C:\Users\
’Username’
\Documents\Viso Systems\Light Inspector
Or if stored in dropbox:
C:\Users\
’username’
\Dropbox
11.2.
Connect Power
The BaseSpion comes with a
standard IEC power-in
connector and with a standard
euro power cable, but any
power cable can be used as the
BaseSpion supports any outlet
voltage from 90-260VAC.
The power-in connector
supplies power to the
goniometer motor, power
analyzer and the light source
being measured. Which means
the power feed to the system is
also what is being delivered to
the light source to be measured.
11.3.
AC Power Supply Cable Plug
Warning: Risk of an electric shock! Plug installation shall be performed by a qualified
electrician.
A grounding-type (earthed) power plug that fits the local power outlet must be used.
You can acquire an IEC power cable with a suitable grounding-type plug from most of
consumer electronics stores.
When installing the plug connect pins as follows:
▪
Yellow and green wire to grounding (earth)
