UltraReceiver User Manual
Specification
Issue No: 3
Page: 12
Ref: ULRX-ASUM-700X
Copyright © 2018 Vislink plc
Connector type LEMO EEG0B305CLV
Lemo Conn
Function - Analogue
Pin 1
Left Line + (Line)
Pin 2
Left Line - (Return)
Pin 3
GND
Pin 4
Right Line + (Line)
Pin 5
Right Line - (Return)
Table 3-3
Audio 2 Pin Out
CAUTION: You may cause permanent damage to the audio output amplifiers if you connect
an audio input that has Phantom power applied. Internal protection is provided
on the audio outputs, but damage may still occur. Any damage caused via the
audio outputs will not be covered by warranty.
Specification as Audio 1. See Section 3.9.
Connector:
LEMO 6-pin socket - EEF.0B.306.CLL
‘Lemo’ Type
Function
Pin 1
0v
Pin 2
NC
Pin 3
CCU control Tx (output)
Pin 4
Status output (open drain)
Pin 5
Reserved for future use
Pin 6
NC
Table 3-4
Camera Control/Alarm Pin Out
The Status output is an open-drain output. When the system detects an alarm, it is pulled
low by default. It is also possible to drive it manually via the menus (see Section 5.3.2) or a
web page. Max Voltage 20V; Max Current 1A.
Standard 10/100 Ethernet connection for control of the unit using Web Browser (HTTP)
and Network Management (SNMP).
A copy of the unit’s SNMP MIB (Management Information Base) can be downloaded from
link on the internal web browser. See Section 5.8 to connect to the unit via the internal
web browser,
Always use this link as the reference for any SNMP application, to ensure that the version
relevant to the current code release is used.
To configure the unit via the inbuilt web page, see Section 5.8 to connect to the unit.
