UltraDecoder Operators Manual
Quick Start Guide
Issue: 4
5
Ref: ULTD-ASUM-7001
Copyright © 2016 Vislink plc
In the first instance, we recommend configuring the unit using the front panel interface
controls.
The procedure for configuring the web interface is as follows:
1.
First, make the direct Ethernet connections on the rear panel using the supplied
cables, as described in Section 2.
2.
If required, configure the Ethernet Control port with the appropriate IP Address,
Mask and Gateway to match your network settings. The settings for this can be
found from the front panel by selecting:
Menu | System | Remote Interfaces | Ethernet Port.
3.
If you are connecting the IP Video port and Eth. 1 to your network, configure the IP
Video port by selecting:
Menu | Unit Setup | IP Options | IP Port Setup
NOTE: If you are using a direct connection, the default values can be left as is.
NOTE: If a direct connection is used between the IP Video and Eth. 1 ports then the unit
can only be used in ASI input mode.
4.
Power the unit off and safely remove the supplied cables.
CAUTION: Make sure you connect the Ethernet ports to your network before reapplying
power to avoid the control and decoder subsystems loosing communication.
Access the Web Interface using the same IP address as the Ethernet Control port.
