Page 4
Hi-Lite™ 30 LED contour tube specification & installation
v6 – June 2021
Visive Group Limited
Ash Road South, Wrexham Industrial Estate, Wrexham, LL13 9UG +44 (0) 1978 660181
www.visivegroup.com
The installation
(continued)
6.
If the section is the end of the electrical
circuit, a connector blanking plug (supplied
with power supply) MUST be fitted to the
unused connector. Failure to fit the blanking
plug may allow water to penetrate the
system, which will cause the CSC safety
device to remove power.
7.
Hook the Hi-Lite™ 30 tube section into the
top of the clip as shown, then rotate down
until the bottom edge clips into place. Ensure
the tube is properly located in the clip and
that no wires are trapped. A ‘click’ should be
heard when the tube is located correctly.
8.
Hi-Lite™ 30 tube section clipped in place,
with the cable positioned ready to connect
to the next section.
9.
Connect the next tube, looping the cable
around in the rear channel. Once again
leave a loop of cable to allow for thermal
movement.
10.
In order to maintain weather sealing
connections must be properly made. When
connected correctly the two halves will
be locked together and will not pull apart
without first releasing the locking tab.
Connector blanking plug
11.
Viewed from the rear of the tube, the
connection is hidden within the rear channel.
When fixing the second section, check
carefully that the cables are not trapped and
sit freely between the tube and the clips.
Locking tab
