3.0 Assembly Instructions
4.1 Installation Instructions:
Camera can be mounted using magnet and
attaching hardware. These are the steps
required to attach the magnet to the camera.
1. Position and align center hole of camera
and bracket assembly on top of magnet.
2. Install bolt from underside of magnet and
secure with flat washer and nut. Tighten
this connection.
Tip: Although magnet contains 65lb pull force, it
we recommend mounting your camera on a flat
surface, and a zip tie be used in addition to
fasten the camera as a preventative measure in
the event the camera is knocked off.
1. Slotted holes of the universal base mount
can be used to position and permanently
attach the monitor base to structure.
2. Installer must ensure that attaching
hardware is suitable to support the
weight of monitor and base.
3. Once the base has been fastened into
position the monitor can be installed.
Adjust monitor to desired position and
tighten the screws on the side of the
monitor
4. Optional suction cup mounts are also
available through your local dealer.
(Use Figure On Previous Page)
Connect
MONITOR
harness to the
MAIN HARNESS MONITOR INPUT
. Ensure arrows are aligned
on outer jacket of cable ends. Turn silver cable connector nut clockwise to secure connection of
the cables (IF YOU BEND THE PINS IT VOIDS THE WARRANTY). Ref. Picture Below & Fig.3
3
