IMPORTANT NOTES
INSTRUCTIONS TO PROGRAM A NEW
TRANSMITTER ( REMOTE CONTROL)
On the following page you will find a diagram on where you can identify the program
-
ming button on the receiver.
• If the button on the transmitter (remote) is not pressed within 15 seconds of the LED
light flashing, the receiver will exit programming and the LED light will turn off.
• If the transmitter (remote) has been programmed already, you will see the receivers
channel light turn on steadily and then start flashing again. The transmitter (remote) will
not be able to be programmed a second time.
• One receiver can program up to 50 transmitters (remotes).
Each VIS-8004 Visionis receiver can program up to 50 transmitters (remotes) (VIS-8005).
Before you program this function make sure you have one of your remotes on hand.
Now press the “Learning Button” once and release it right away. Then immediately press
the button on the remote one time and release it.
After that has been done, you will see the LED light on the receiver quickly flash and this
means that the remote has been programmed.
The receiver can hold as many as 50 remotes at the same time simultaneously.
Deleting Remotes
If your remote has been lost or misplaced or you need to delete it from the receiver for any
Reason, go ahead and press the “Learning Button” for about 8 seconds until you see that
the red solid light goes away.
Warning:
This feature will delete all the remotes that you have programmed. If you have other
remotes, they must be reprogrammed.
PROGRAMMING DIFFERENT
FUNCTIONS ON THE RECEIVER
The receiver can be programmed to five different functions. To locate the function mode
button on the receiver look at the diagram on the following page.
4-Second Delay Function (this is the Default Function):
When the transmitter (remo-
te) button is pressed, the receiver will turn on for 4 seconds and automatically turn off
after the 4 seconds.
Press on Function:
As long as the Transmitter (remote) Button is pressed, the receiver
will stay on.
