ON/ Off Toggle Function (L):
This function works exactly like an on/off switch. When the
Transmitter (remote) button is pressed once, the receiver turns on. When the transmitter
(remote) is pressed again the relay turns off.
Latched:
Press transmitter button A, the receiver relay A is on, Press transmitter button
B, the receiver relay A will stop work.
SELECTING THE DIFFERENT BLACK
JUMPER FUNCTION ON THE RECEIVER
To program the correct function on your receiver you must take off the main black
cap of the receiver. On the right-hand side, you will find three little Jumper terminals. The
terminals are defined below. To implement the function needed simply remove the black
jumper and put it on the terminal function of your choosing.
Jumper Definitions
A. Signal 3s = Jumper in 1, disconnect 2,3
B. Signal Latch = Jumper in 2, disconnect 1,3
C. Signal Momentary = Jumper in 3, disconnect 1,2
D. Signal Toggle = 1.2.3 unconnected
WIRING DIAGRAM
Wire Definition:
C = Blue:
NO
B = Yellow:
Com
A = White:
NC
Red:
+
Black:
-
