Visioneer OneTouch 9000, Installation Manual

Page: 8 / 68

4
V
ISIONEER
9000 USB S
CANNER
I
NSTALLATION
G
UIDE
W
HAT
Y
OU
N
EED
To use the 9000 OneTouch scanner and software, you need the
following:
■
IBM PC (or 100-percent compatible) Pentium or equivalent
■
Microsoft Windows 98, Windows 2000, Windows Me, or
Windows XP
■
One available Universal Serial Bus (USB) port; the scanner can connect
to either a USB1.1 or to a faster USB 2.0 port (see the note below)
■
Available internal memory (RAM):
■
Windows 98—32 megabytes (MB) or more
■
Windows 2000, Me, or XP—64 MB or more;
128 MB recommended for Windows XP
■
70 MB of free hard disk space
■
A VGA or SVGA monitor. Recommended settings for your monitor
are as many colors as possible—High Color (16-bit), True Color
(24-bit or 32-bit). Set the resolution to at least 800 by 600 pixels.
To set your monitor’s colors and resolution, open the Windows
Control Panel, double-click Display, and then click the Settings tab.
■
A CD-ROM drive
Note : The new USB 2.0 ports operate at higher speeds than USB 1.1
ports. If your computer is not equipped with USB 2.0 ports, you can
add them with the Visioneer Hi-Speed USB 2.0 PCI Card. Please
visit the Visioneer web site at www.visioneer.com for ordering
information, or contact the dealer where you purchased your
Visioneer 9000 OneTouch USB scanner. However, you do not have
to add USB 2.0 ports to the computer. Your scanner automatically
works with both USB 1.1 and USB 2.0 ports.