IMPORTANT: Controllers may only allow to configure signed values. In order to set values in the range 128
… 255 the value sent in the application shall be the desired value minus 256. For example: to set a
parameter to 200? it may be needed to set a value of 200 minus 256 = minus 56. In case of two byte value
the same logic applies: Values greater than 32768 may needed to be given as negative values too.
Siren Strobe Mode (Parameter Number 0, Parameter Size 1) defines the reaction of the siren
Value
Description
0
Strobe and Siren (Default)
1
Siren only
2
Strobe only
Alarm auto stop (Parameter Number 1, Parameter Size 1) defines the auto time out of the alarm indication
Value
Description
1
60 seconds
2
120 seconds
3
no automated off
0
30 seconds (Default)
Command Classes
Supported Command Classes
Battery (version 1)
Basic (version 1)
Binary Switch (version 1)
Version (version 1)
Configuration (version 1)
Manufacturer Specific (version 1)
Technical Data
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 4