Introduction
Thanks for choosing the Vision’s In-Wall Switch module of the home automation device.
This module is a Z-
Wave™ enabled device (interoperable, two-way RF mesh networking
technology) and is fully compatible with any Z-
Wave™ enabled network. Every mains
powered Z-Wave enabled device acts as a signal repeater and multiple devices result in
more possible transmission routes which helps eliminate “RF dead-sports”.
Z-
Wave™ enabled devices displaying the Z-Wave™ logo can also be used with it
regardless of the manufacturer, and ours can also be used in other
manufacturer’s
Z-
Wave™ enabled networks. With special design, this module can fit into most of
electronic box in the market. This module will send On/Off signal to the appliance that
attached to this module by receiving Z-
Wave™ signal from controller or user can
manually turn on/off the appliance by wall switch.
Product Description & Specification
Specification:
Package Content
Protocol: Z-
Wave™ (ZM3102N)
Frequency Range:
865.22MHz (ZL7431IN)
868.42MHz (ZL7431EU)
869.00MHz (ZL7431RU)
908.42MHz (ZL7431US)
920.00MHz (ZL7431JP)
921.42MHz (ZL7431BR)
Operating Range: Up to 100 feet line of sight
Operating Temp.: -15°C~ 60°C (5°F~140°F)
Operating Voltage:100VAC~240VAC
Resistive Load:
800W for 110VAC
1300W for 220VAC
1pc ZL 7431 In-Wall Switch,
1 Relay
1pc Installation & Operation
Manual
Z-
Wave™ Command Class
COMMAND_CLASS_ASSOCIATION
COMMAND_CLASS_CONFIGUARION
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_SWITCH_ALL
COMMAND_CLASS_SWITCH_BINARY
mapping
COMMAND_CLASS_BASIC
COMMAND_CLASS_VERSION
Installation
Notice: If you are installing the entire Z-
Wave™ system for the first time, please refer to
the installation guide of Z-
Wave™ Interface Controller before installing ZL7431 In-Wall
Switch Module.
1.
Following the wiring diagram to install ZL7431 according to your varied
requirements.
Note: Place antenna toward the surface and away from metal to get better signal.
2.
For
“Inclusion”
in (adding to) a network
:
Put the Z-
Wave™ Interface Controller
into “inclusion” mode, and following its instruction to add the ZL 7431 to your
controller. To get in the “inclusion” mode, the distance between module and
controller is suggested to be in one meter. Turn on and turn off the wall switch that
connects with ZL 7431 module 4 times to be included (or press the Program SW 4
times within 2 seconds to be included), then LED shall stop flashing.
For
“Exclusion”
from (removing from) a network: Put the Z-
Wave™ Interface
Controller into “exclusion” mode, and following its instruction to delete the ZL 7431
from your controller. Turn on and turn off the wall switch that connects with ZL
7431 module 4 times to be excluded (or press the Program SW 4 times within 2
seconds to be excluded), then LED shall start flashing.
3.
Status of “ON” (Binary Switch Set 0xFF or wall switch ON)
S
tatus of “OFF” (Binary Switch Set 0x00 or wall switch OFF)
-1-
-2-
