14.
Factory Default Reset:
Trigger the rear cover switch to send the Alarm Report and
trigger the reed switch (close & open) 5 times in 10 seconds, ZD2105 will send the
“Device Reset Locally Notification” command and reset to the factory default.
(Remark: This is to be used only in the case of primary controller being inoperable or
otherwise unavailable.)
15. Support OTA Firmware update from controller. Please refer to your controller manual.
Once OTA function success, we recommend you exclusive the device & inclusive
again before use the device.
16. Support SECURITY S0, SECURITY S2 UNAUTHENTICATED & SECURITY S2
AUTHENTICATED.
17. Support SmartStart, please scan the QR Code from ZD2105 for SmartStart.
QR code
and PIN is located on the device, also there is a Full DSK string on the enclosed DSK
card as below image:
18. A Security Enabled Z-Wave Controller must be used to fully utilize the products.
-5-
