VIS_ZP3102
Z-Wave Motion Detector
Firmware Version : 4.84
Quick Start
A
This device is a wireless Z-Wave actor. A single click on the programming switch on the back side of
the enclosure (behind little hole) will confirm Inclusion and Exclusion. Opening the enclosure will wake up
the device and keep it awake.
Please refer to the chapters below for detailed information about all aspects of the products usage.
Product description
This motion detector (PIR = passive infrared receiver) detects the presence of a person in a room. The units
send information to a controller or any other associated Z-Wave device. The device is protected by a tamper
switch that will issue an alarm when the enclosure if opened. Beside the Motion detection the device also
reports the ambient temperature.
Installation Guidelines
1. Release the cover tap to open the cover.
2. Ensure that the system is properly powered. Insert the CR123A battery into the batter compartment and
the LED will start flashing slowly. This means that the device is not yet included into a Z-Wave network.
(c) 2016 Z-Wave Europe GmbH, Antonstr. 3, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 1
