Association Groups:
1 Control Device when Motion is detected (max. nodes in group: 5)
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can
adapt the function better to user needs or unlock further enhanced features.
IMPORTANT: Controllers may only allow to configure signed values. In order to set values in the range 128
… 255 the value sent in the application shall be the desired value minus 256. For example: to set a
parameter to 200? it may be needed to set a value of 200 minus 256 = minus 56. In case of two byte value
the same logic applies: Values greater than 32768 may needed to be given as negative values too.
Re-Trigger Waiting Time (Parameter Number 1, Parameter Size 1) Time until an associated device will turn
off if no new movement is detected
Value
Description
129 — 127 Seconds
Technical Data
Battery Type
1 * CR123A
Explorer Frame Support Yes
SDK
4.54.00
Device Type
Slave with routing capabilities
Generic Device Class
Binary Sensor
Specific Device Class
Routing Binary Sensor
Routing
No
FLiRS
No
Firmware Version
4.84
(c) 2016 Z-Wave Europe GmbH, Antonstr. 3, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 4
