Vision VE-810, Operation Manual

Page: 31 / 69

Chapter 3 - Operations 31
Pause -
The pause button is used to momentarily stop the machine from engraving. If
you press the pause button while the machine is engraving, the VE-810 will wait until the
end of the current letter or logo that it is engraving and then lift the cutter up, shut the
engraving motor off and stop. Pressing the start button will resume the engraving where it
left off.
Stop -
The stop button is used to stop the machine from engraving. If you press the stop
button while the machine is engraving, the VE-810 will stop immediately, shut the
engraving motor off and lift the cutter up. Pressing the start button will resume the
engraving where it left off. While stopped, the Goto Home Button and Goto Offset Button
will return the cutter back to home or to the offset.
Hint: Holding the ALT button down
while pressing any jog button will
increase the jog speed.
X & Y Jog buttons - The X & Y jog buttons are used to move the position of the spindle
on the T-Slot table work area. The X jog buttons will move the engraving spindle left and
right. The Y jog buttons will move the t-slot table front to back. The machine will jog at the
speed that the XY speed knob is set at. Increase the XY speed knob to increase the jog
speed.
Hint: Holding the ALT button down
while pressing any jog button will
increase the jog speed.