Vision MAX Pro, User Manual

Page: 15 / 69

15
MODEM SETUP
MODEM SETUP
# 1 – Type Of Connection – Choose if you will be allowing remote connections to the DVR to occur.
Selectable network bandwidth. If you would like to use a modem to communicate with center locations, it
may be necessary to run the PPP setup utility. Please see Appendix A for more information.
# 2 – Password – You can enter a 4 digit password to be used when a remote computer attempts to
make a connection. The default password is 1234.
# 3 – Motion For Emergency Messages – Select the cameras that will cause a connection to occur to the
emergency monitoring software. The connection will occur to the Emergency site below.
# 4 - Sensors For Emergency - Select the sensors that you want to cause a connection to the
emergency site listed when the sensor is activated.
# 5 – Emergency Phone Numbers / Emergency IP Address – Select how you would like the DVR to
make an emergency connection, and then enter either the phone numbers or the IP address of the
remote center software.
# 6 – Transfer Time – Select the length of time that the emergency connection should be
maintained. If the situation that caused the connection to occur happens again during the transfer time,
the time will be started again.