WIRING INSTALLATION
1)
Find a suitable place to mount Relay [Part R1] leaving enough room for Power
& Ground Wire [Parts W1 & W2] to reach the Battery & the Deutsch Connector
Wiring [Parts C1 & C2] to reach the Lights. Mount Relay.
2)
Run Power Wire [Part W1] & Ground Wire [Part W2] to the Battery. Connect
the Power Wire [Part W1] to the Positive (+) Battery Terminal & connect the
Ground Wire [Part W2] to the Negative (-) Battery Terminal.
3)
Run the Deutsch Connector Wiring [Parts C1 & C2] to each Light and Plug in.
It doesn’t matter which Deutsch Connector plugs into which Light.
4)
Unplug Power Wire [Part W3(+)] from the Toggle Switch [Part S1]. Run Power
Wire [Part W3(+)] to the Vehicles Fire Wall at the point that you will bring the
Wire through to the inside of the Cab (using a Factory Rubber or Plastic
Grommet is suggested). Run Power Wire [Part W3(+)] to the inside of the Cab.
Note: This Wire can be extended if necessary.
5)
Find a suitable place to Drill the Hole needed to mount the Toggle Switch
[Part S1] and Continue to run the Power Wire [Part W3(+)] to that location.
Plug the Power Wire [Part W3(+)] into Outside Pin of Toggle Switch [Part S1].
It doesn’t matter which Outside Pin you use.
6)
Drill the Hole to the required size for the Threaded Neck Portion of the Toggle
Switch [Part S1]. Mount Toggle Switch [Part S1].
7)
Find a Factory Positive (+) Constant Wire, Positive (+) Ignition Wire, or Positive
(+) Parking Light Wire depending on how you want your Toggle Switch
[Part S1] to operate your Vision X Lights. This is the Wire that you will connect
the Power Wire [Part W4(+)] to. There are many different ways to connect or
“Tap” into a Wire (soldering is suggested).
8)
Connect the Power Wire [Part W4(+)] to the Factory Positive (+) Wire you have
chosen.
1)
If you selected a Constant Wire to Connect the Power Wire
[Part W4(+)] to then you will be able to use the Toggle Switch to turn
you Vision X Lights On & Off at all times.
2)
If you selected an Ignition/Acc Wire to Connect the Power Wire
[Part W4(+)] to then you will have to have the Ignition turned on to us
e the Toggle Switch to turn you Vision X Lights On & Off.
3)
If you selected a Parking Light Wire to Connect the Power Wire
[Part W4(+)] to then you will have to have the Parking Lights turned
on to use the Toggle Switch to turn you Vision X Lights On & Off.
VISION X OPTIMUS SINGLE KIT
COMPONENTS KEY
Part (R1) Relay
Part (W1) Ground Wire for Relay Coil
a. 12 Volt Negative (-) Input Wire for Relay Pin 86
Part (W2) Power Wire for Relay Coil
a. 12 Volt Positive (+) Input Wire for Relay Pin 30
Parts (C1 & C2) Deutsch Connectors for Lights
a. Attached to12 Volt Positive (+) Power Wires for Relay Pin 87
Part (W3) Power Wire for Relay Input
a.12 Volt Positive (+) Input Wire for Relay Pin 85 [Part R1]
Part (S1) Toggle Switch
Part (W4) Power Wire for Switch Input
a. 12 Volt Positive (+) Input Wire for Switch [Part S1]0
(+)
(-)
(W1)
(W2)
(R1)
(C1)
(W3)
(W4)
(S1)
(C2)
87
86
85
30
Example Relay
89
Not Used
(+)
